V30 Antarctic Microturbine

The Forgen Antarctic Model is the most robust vertical axis machine on the market today and is designed for use in the most extreme environments. Hundreds of these units have been and continue to be deployed in the Antarctic every year. The Antarctic Model comes complete with low temperature bearings and cable and is designed to produce more current at higher wind speeds such as those experienced in the Antarctic. It also comes with side mount arrangement and more sturdy connections to further improve the units strength.

Forgen Vertical Axis Wind Turbines (VAWT) technology is used in many different applications all over the world including government scientific research institutions, on sailing boats, and increasingly in many varied commercial applications where small scale remote power is required.

The sophisticated technology behind the turbines enables the maximum advantage to be taken of even the most average weather conditions. However, Forgen turbines really come into their own when faced with extreme environments such as those found in the Arctic and Antarctic.

The Forgen Antarctic Model measures just 200 mm in diameter in plan dimensions and just over 300 mm tall. This small entry level unit is designed for single battery installations up to 150Ah of battery.

The Antarctic model is suitable for temperatures down to –50 degrees Celsius. Uniquely, during high speed wind tunnel tests, this model was still spinning and delivering output in 100mph winds, which is often seen as a challenge for many horizontal axis machines.

The Antarctic model comes complete with low temperature bearings and cable and is wired in a delta configuration. It also comes with side mount arrangement, ideal for use in extreme environments of cold temperature and high winds. The unit is available in a variety of colours to suit your application. 

  • V30 Antarctic Gallery Image.jpg
  • V30 Antarctic.jpg
  • V30 Antarctic in situ.jpg

Nominal Output:

15 Watts @ 20ms-1
Rotor Diameter: 200mm
Vane height: 310mm
Output voltage: Suitable for 12VDC or 24VDC
Start-up wind speed: Approximately 3~3.5ms-1 (5.82~7.82 knots)
Cut-in wind speed: Approximately 4ms-1 (8.95 knots)
Generator: Protected Three Phase permanent magnet
Noise Level: Less than 5dB, 5m from unit
Coating: All exposed parts powder coated Aluminum, centre shaft cold anodised
Bearing: Low temperature, fully sealed
Temperature range: -50oc to +50oc
Wire: 10 metres standard
Mounting option: Side Mount (included)
Weight: 8Kgs
Installation: Easy and simple
Warranty: 2 years

Special Features:

  • Safe and Silent in operation                       
  • Non blade design for user safety
  • No maintenance required
  • Corrosion resistant components
  • Electrical circuit fully protected against overload
  • Solid state rectifier

Note: Result from internal wind tunnel testing. Field results may vary

Prolectric Services Ltd operate a policy of continuous improvement and reserve the right to change its technical data and performance at any time.

Applications

  • Scientific Research
  • Extreme Environments
  • Remote Battery Charging
  • Off shore applications

Call or email us about our Forgen V30 Antarctic Microturbine

01275 400 570    
info@prolectric.co.uk

  • Lloyds Register Logo
  • Safe Contractor Logo
  • exor Gold Contractor Logo
  • Approved Installer Logo
  • Domestic Installer Logo
Checkbox Check Arrow next Arrow Previous Contact Bubble Twitter YouTube LinkedIn Facebook Location