Forgen Ventus 70

Formerly known as the Forgen 1000, the Forgen Ventus 70 is a robust vertical axis machine designed for multiple battery bank installations typically up to 450Ah of battery. Suitable for many different applications including in the Antarctic. This unit comes complete with standard wedge mount and bracket.

Forgen Vertical Axis Wind Turbines (VAWT) technology is used in many different applications all over the world including government scientific research institutions, on sailing boats, and increasingly in many varied commercial applications where small scale remote power is required.

The sophisticated technology behind the turbines enables the maximum advantage to be taken of even the most average weather conditions. However, Forgen turbines really come into their own when faced with extreme environments such as those found in the Arctic and Antarctic as well as offshore marine applications.

The Forgen Ventus 70 is the larger scale vertical axis machine in our range and measures just 300 mm in diameter in plan dimensions and just over 465 mm tall. This unit is designed for multiple battery bank installations up to 450Ah of battery.

There are also two models offered in the 70 series range, the normal temperature model (NT) and the low temperature model (LT).  The Forgen v70 NT is suitable for temperatures down to -20 degrees Celsius, whereas the low temperature models are designed to continue operating in temperatures down to -50 degrees Celsius.  Like the Forgen v30 model, during high speed wind tunnel tests the Forgen 1000 model was still spinning and delivering output in 100mph winds, which is often seen as a challenge for many horizontal axis machines.

This unit comes complete with standard wedge mount and bracket. If alternative mounting arrangements are required please refer to thew accessories section.

  • Ventus 30.jpg
  • Microturbine marine application.jpg
  • Microturbines on bouy.jpg

 Nominal Output:  25 Watts @ 16ms-1
Rotor Diameter: 300mm
Vane height: 465mm
Output voltage: Suitable for 12VDC or 24VDC
Start-up wind speed: Approximately 2ms-1 (3.88knots)
Cut-in wind speed: Approximately 3.5ms-1 (7.82 knots)
Generator: Three Phase permanent magnet
Noise Level: Less than 5dB, 5m from unit
Coating: All exposed parts powder coated Aluminum, center shaft cold anodised
Bearing: Fully sealed
Temperature range: -50oc to +50oc
Wire: 10 meters standard
Mounting option: Pole mount, Wedge mount, Side mount, Rail mount
Weight: 13Kgs
Installation: Easy and simple
Warranty: 2 years

Special Features:

  • Safe and Silent in operation
  • Non blade design for user safety
  • No maintenance required
  • Corrosion resistant components
  • Electrical circuit fully protected against overload

Note: Result from internal wind tunnel testing. Field results may vary.


Call or email us about our Forgen Ventus 70 Microturbine

01275 400 570    
info@prolectric.co.uk

  • Lloyds Register Logo
  • Safe Contractor Logo
  • exor Gold Contractor Logo
  • Approved Installer Logo
  • Domestic Installer Logo
Checkbox Check Arrow next Arrow Previous Contact Bubble Twitter YouTube LinkedIn Facebook Location