V30 Microturbine

Previously known as the Forgen 500, the Forgen Ventus 30 is a robust vertical axis machine designed for single battery installations typically up to 150Ah of battery. Suitable for many different applications including in the Antarctic. This product comes complete with standard wedge mount and bracket. Alternative mounting options cost extra.

Forgen Vertical Axis Wind Turbines (VAWT) technology is used in many different applications all over the world including government scientific research institutions, on sailing boats, and increasingly in many varied commercial applications where small scale remote power is required.

The sophisticated technology behind the turbines enables the maximum advantage to be taken of even the most average weather conditions. However, Forgen turbines really come into their own when faced with extreme environments such as those found in the Arctic and Antarctic as well as offshore marine applications.

The Forgen Ventus 30 is the smallest vertical axis machine in our range and measures just 200 mm in diameter in plan dimensions and just over 300 mm tall. This small entry level unit is designed for single battery installations up to 150Ah of battery.

There are two models offered in the range, the normal temperature model (NT) and the low temperature model (LT). The Forgen Ventus 30 is suitable for temperatures down to -20 degrees Celsius, whereas the low temperature models are designed to continue operating in temperatures down to -50 degrees Celsius. Uniquely, during high speed wind tunnel tests the Forgen Ventus 30 model was still spinning and delivering output in 100mph winds, which is often seen as a challenge for many horizontal axis machines.

This product comes complete with standard wedge mount and bracket. Alternative mounting options cost extra. Please refer to our Accessories section.

The Forgen Ventus 30 does not require a charge controller.

  • Ventus 30.jpg
  • Microturbine marine application.jpg
  • Microturbines on bouy.jpg

Nominal Output: 15 Watts @ 20ms-1
Rotor Diameter: 200mm
Vane height: 310mm
Output voltage: Suitable for 12VDC
Start-up wind speed: Approximately 3~3.5ms-1 (5.82~7.82 knots)
Cut-in wind speed: Approximately 4ms-1 (8.95 knots)
Generator: Protected Three Phase permanent magnet
Noise Level: Less than 5dB, 5m from unit
Coating: All exposed parts powder coated Aluminum, centre shaft cold anodised
Bearing: Fully sealed
Temperature range: -50oc to +50oc
Wire: 10 meters standard
Mounting option: Pole mount, Wedge mount, Side mount, Rail mount
Weight: 8Kgs
Installation: Easy and simple
Warranty: 2 years


Special Features:

  • Safe and Silent in operation                       
  • Non blade design for user safety
  • No maintenance required
  • Corrosion resistant components
  • Electrical circuit fully protected against overload
  • Solid state rectifier

Note: Result from internal wind tunnel testing. Field results may vary

Prolectric Services operate a policy of continuous improvement and reserve the right to change its technical data and performance at any time.

Applications

  • Trickle charging of small battery banks
  • Small power needs
  • Marine sector
  • Data monitoring

Call or email us about our Forgen Ventus 30 Microturbine

01275 400 570    
info@prolectric.co.uk

  • Lloyds Register Logo
  • Safe Contractor Logo
  • exor Gold Contractor Logo
  • Approved Installer Logo
  • Domestic Installer Logo
Checkbox Check Arrow next Arrow Previous Contact Bubble Twitter YouTube LinkedIn Facebook Location